Roof Lantern Placement
Farhaan Asad
5 years ago
I have opted to have a roof lantern as part of flat roof extension however I cannot decide whether to go for one large or two smaller lanterns. I cannot also decide whether It would be better to have them placed horizontally or vertically across the flat roof.
I have placed a pink highlight on the plan where the flat roof begins.
Appreciate any advice on this
I have placed a pink highlight on the plan where the flat roof begins.
Appreciate any advice on this
Featured Answer
Comments (15)
chapss89
5 years agochapss89
5 years agoRelated Discussions
Position of roof lantern(s) and french vs sliding doors
Comments (0)Hello, We are about to finalise our potential single-storey extension of a 1930s semi-detached build and would like some advise. Question 1 We are creating a family room with adjoining kitchen, that opens up onto a patio area and garden. The family room is 5.8m deep, and will be approx 5.7m wide. Decisions that we are contemplating: 1. would like to have a single large roof lantern in the middle, say3.5m x 3.5m (orange dotted line in floor plan). However to have this size, I will need more structural beams (ie extra expense) 2. architect has suggested 2x 2.5x1.2m roof lanterns that run parallel in the room (blue/green dotted lines in floor plan)- this means will only need 1 structural beam in the middle, and thus more cost effective. NB. In addition to the roof lantern(s) in the living room, we will have either a flat or roof lantern in the kitchen which will be 3x1m Whilst we can to keep the costs reasonable, if it only costs a little bit more but has more light (given the dining room area will not have direct light) would prefer the first option - welcome any thoughts. Question 2 For the doors leading to the patio, I would like to have 2 sets of double french doors with sidelights. Given it is a 5.7m wide space, there is not enough space for 2x a pair double french doors with 2 sidelights. Option 1: I was thinking of having 2 pair of double french doors with a single sidelight (1 has left side light, and 1 has a right side light) 3 panel french door attached, with a slim brick wall in between. so it would be: <-1m wall space-> <-1 set of double french doors with left sidelight-> <-1 set of double french doors with right sidelight-> <-1m wall space->. The french doors would be in line with the roof lantern option 2 above. (cant find an exact picture, however have double french doors next to each other in the picture attached) Alternatively i i leave 1m wall on each side, leaving about 3.7m of door space, I was thinking of: Option 2. a single set of double french doors with sidelights in the middle of the wall space, and possibly tall windows along until the end of each side? Option 3. sliding door with minimal profile? Would really appreciate any advise....See MoreLighting to go round my roof lantern.
Comments (2)Thanks, this is exactly what we've decided to do 👍🏻...See MoreRoof lantern and pendant lights
Comments (1)Hi Sana We have created bespoke lighting solutions for people in the past. Yours is a tricky set up and depends where the power source comes from but perhaps a bar suspended across the lantern with pendants hanging from it is an option. Or a lengthy bar across the whole island that also goes across the gap. Email some photos to sales@nigeltyas.co.uk if you want us to take a look at it for you. Our range of ceiling lights and pendants are on the website so adpating something to suit your arrangement is usually possible as we manufacture everything to order. Best wishes Gareth...See MoreRoof Lantern - Steel Beams and Goal Post Needed?
Comments (4)Best to ask your structural engineer if there is a way to support this in timber rather than steel. They can do the calcs for you. Ask them too how much the door would need to reduce to create sufficient brickwork to rest on, and if there are any other options. If its just a case of reducing the width to each side by about 150mm of brickwork and that saves you the whole steel across the top of the back wall then potentially that would be a compromise that's worth doing to protect your budget. Only you can decide what compromises are worth making. The only person able to check the calcs and put forward an alternative are your structural engineer along with your architect. They should be coordinating the design between them and explaining your options so that you can make an informed decision. If they're not able to do that then change them. If you're working with professionals and still find yourself seeking the advice of strangers on the internet then they are not doing their job well enough and you don't have to stick with them....See Moreiyanini14
5 years agoFarhaan Asad
5 years agoFarhaan Asad
5 years agominipie
5 years agoiyanini14
5 years agoiyanini14
5 years agoFarhaan Asad
5 years ago
PROMedina Joinery Ltd
5 years agoHi,
It is a personal choice, although we would recommend from our experience a large rectangular roof lantern fitted across the width of the roof. Here are some timber Roof Lanterns we manufactured and fitted recently:
If you need any advise or just want a chat please don't hesitate to contact us tel: 023 9263 7380 or have a look at our website Gallery and also our Gallery Carousel for ideas.
Regards,
PROYES Glazing Solutions
5 years ago
Farhaan AsadOriginal Author