Make Your Own Scented Eucalyptus Table Garland
Eucalyptus leaves, white blossoms and air plants combine in a gorgeous, long-lasting arrangement for your table or sideboard
With just a few plants and florist supplies, you can make a long-lasting table garland that’s fresh and simple. Sammy Go of Bud Botanical Banditry demonstrates how to create this stunning centrepiece.
The whole process should take less than an hour, depending on the length of your garland. Once you get into the groove, you’ll find a rhythm. “Don’t think too hard about it,” says Go. “Just go with your instinct and it will come naturally.”
Plant Materials
Tools
- Seeded eucalyptus (for the base of the garland)
- Blue gum eucalyptus
- ‘Silver Bells’ eucalyptus pods
- Paperwhites (or, for a less fragrant alternative, cyclamen). Go says, “You would have to get a potted cyclamen from a nursery and just snip off the flowers.”
- Tillandsia
Tools
- Gardening shears
- Floral wire
- Floral water tubes
Pick large, leafy eucalyptus leaves that aren’t brown or brittle. It takes about three bunches of seeded eucalyptus to make a 4ft-long garland.
Start with one large branch of seeded eucalyptus, then add a few smaller branches to it, fanning them out to the sides. The width you make this beginning bunch will determine the final overall width of the garland.
Start with one large branch of seeded eucalyptus, then add a few smaller branches to it, fanning them out to the sides. The width you make this beginning bunch will determine the final overall width of the garland.
Wrap each section with floral wire, much as you would tie ribbons around a maypole. Tie loosely so the leaves look natural and stay open.
Continue to add more eucalyptus leaves below the starting point and secure them with floral wire. Add the blue gum eucalyptus and Silver Bells pods as you build the garland.
There’s no specific pattern or way to add the accent plants. Do what feels natural to you. What makes this centrepiece shine is its organic, unfussy look.
Stop adding material when you reach the halfway point of what you want the final length of the garland to be. For example, if you want it to be 4ft long, stop when this first piece reaches about 2ft long.
Repeat the process to make the other half of the garland. By having two pieces rather than a single one, the ends will match and the piece will look more symmetrical.
To connect the two halves, lay the two ends side by side and nestle them closely together so there are no gaps. Use the floral wire to tie them together. Then lay out the entire centrepiece and remove any excess foliage.
Fill the floral tubes with water and place an individual flower stem in each of them.
In a DIY mood? Check out these ways to revamp drawers with paint
In a DIY mood? Check out these ways to revamp drawers with paint
Gently insert the tubes along the length of the garland, using the eucalyptus leaves to hide them. Drop in the air plants last, spacing them out along the garland as well.
Discover 10 ways to grow and display air plants
Discover 10 ways to grow and display air plants
Because eucalyptus is pretty hardy, the garland will last a week or possibly two. To preserve it as long as possible, keep it in a cool place out of direct sunlight. The paperwhites or cyclamen blossoms will last only a few days; just pull them out and replace them for a longer display.
This green, silver and white garland is unexpected and, if you use paperwhites, you’ll also enjoy their fresh, natural perfume.
Are you tempted to make a garland like this? Or have you made your own version in the past? If so, please share your tips and photos in the Comments below.
Are you tempted to make a garland like this? Or have you made your own version in the past? If so, please share your tips and photos in the Comments below.