What an amazing forum this is. Do hope you have a clearer picture by now. I adore your splashback, it must not be relegated to a utility room. Buy more of the same for that! Perhaps you could frame an extra piece as art in another area. I've painted my kitchen cupboards in 'Hebridean Mist' which goes so well with the slate floor tiles, then a pink fridge freezer and pink edged worktop tiles tie in well. I like to add a little bit of matching colour from one room to another room, moving through the house like that. It givers synergy to all my rooms, none of which are the same colour, but all of which have a hint of another room. Anthology is a fabulous site to look at for lighting. Wayfair has a gorgeous orange glass globe light I want badly! I actually adore the combination of orange, shades of grey, white and black. A simple thing like 1 Cygnus Papilios cushion by Alex Goode can pass one colour into another room.

Please help me choose a counter top, so far I have found this one which matches but I would have preferred something lighter. Suggestions will be appreciated!! Thank you

It's an awkward one. No it shouldn't be like that. It's not awful and I doubt the Quartz is compromised, but it's not perfect and if you're not happy then ..................Check for level.by looking at the bottom of all the units, do they line up? The problem is with the units, not specifically the fitting of the work top. It's the poorly fitted units that have caused the problem with the worktop. However, this should have been noticed and checked for level and that they were solid before the worktop went on. So, as often is in these situations it's 6 of one and half a dozen of the other. I'm presuming that the reason the fitter used shims is because the cupboard below wouldn't go up any further or it would have been completely out of line with the others for whatever reason? The doors are easily adjusted back to level, but the carcass should have been right to start with. Could this be happening because the floor isn't solid? There should have been no movement, especially not that much? I'm wondering if there was a little bounce in the floor such as you may get on floorboard with boarding over the top and the weight of the quartz affected that? I'd take it back up with the worktop fitter and the kitchen fitter together on site.

Book matching is something that good fabricators do. It sounds like you need a good fabricator. Although - as I understand it only certain quartz with a high price tag can be book matched. And you have to do what you are suggesting where you use more than one slab and the wastage adds to the cost. The image is of Dekton not quartz which may be an easier way of getting the result you want.