Hi Lee, No problem : ) With the LED tape, it depends upon how happy you are with soldering : / The tape can be cut at set marked places. It is then possible to solder wires on at these points and then extend the tape. Personally, in your case, I wouldn't cut the tape yet but wait until the integrated dishwasher arrives. Depending upon the model of the dishwasher, it may be possible to fit the aluminium extrusion to the underside of the units and run it past the dishwasher without the door catching. If this isn't possible, you may need to cut the tape and use a joint to fit the extrusion to the plinth under the dishwasher. If you use a slightly deeper extrusion, you can mount the extrusion onto the plinth under the dishwasher by putting the double sided tape onto the side of the extrusion. I think that I probably need to do you a drawing of this to show you what I mean! Do you know which model of integrated dishwasher you're going to fit? Can you remind me where in the country you're based? With the projectors, I've heard of Benq but haven't seen either of the models in the flesh. Are you going to be using a screen with them or just beaming onto a wall? With a screen, the brightness of the projector isn't as important as the screens have a higher 'gain' than a white painted wall - meaning more of the light is reflected back to you. You will also need some way of blackening the room out as this will improve the image quite a bit. We have a projector at home after getting rid of the TV. We found that it totally changed our viewing and gaming habits. The lounge is now dark purple (with the white room we had before, the reflections off the side walls were quite noticeable) and we have thick curtains over the window. You won't regret gaming on a projector : ) We use ours mainly for Skyrim : ) Projectors don't hold their value very well, (we bought ours used), but there should still be bargains to be had with new ones. If you can't get to see one in the flesh, then try to find one that's reviewed well and buy from a shop that will either let you demo the unit or has a good returns policy. We have a JVC X-7 which we are very pleased with. For a surround sound system, do you want the speakers too or just the processor? It may be easier to go through this on the phone. My numbers on my profile : ) Thanks Peter

Glass splashbacks would be perfect to finish your kitchen as they are hard wearing and easy to keep clean. We use Decoglaze here at Alno Bristol as they offer a wide choice of options from glossy or satin, plain or textured and any colour of your choice including matched to any paint colour or can be printed with any image or photo! You could either go full height all around for maximum impact or have a feature piece behind the hob with small upstand elsewhere if you wanted to paint the rest of the walls. Here are some examples Alno kitchens with glass splashbacks

Matching granite and up stands, lovely granite. However, many have mentioned that when tying the back splash and up stands together the difference in the two pieces of granite is quite noticeable, so something to bear in mind. I do think however, that regardless of not wanting glass or tile, you do need something behind a hob.

Thanks to bad renovation timing coinciding with the start of Covid lockdowns, we used DIY removable wallpaper above our upstand as a temporary “make do” measure because all work and shopping had to stop. Three years later (!) we are finally getting around to removing a chimney breast to completely finalise the kitchen, including replastering, and I am fairly certain I will be using the same wallpaper again. The only difference is it will be professionally hung! We have received so many compliments and it’s been shockingly robust, even behind the hob. We used a greyish shiplap patterned wallpaper above a Carrera marble countertop and upstand, with white upper and pale grey lower cabinets.