We are coming to the end of a house renovation and we had wet UFH installed in all our rooms. It is a bungalow however, it is very unusual property with rooms below the bungalow so it is like a house in some respects. We have a mixture of solid floors and suspended timber floors and couldnt have a screeded system because of the weight. We had an ESP overlay board system installed and have found it to be very effective. Ours is run off an ASHP so I cannot tell you how it would work off gas central heating. Our UFH is on 24/7 controlled by thermostats in each room/area. We did install internal wall insulation on all of the external walls and window reveals and voids beneath the floorboards where possible and my understanding is that this is key to efficient and cost effective UFH.

oh old post to practice, the obvious choice is first floor extention but this only if the ground foundation on the back supports for this floor. Its mirroring the outer wall of the ground floor so enough area, there also alternative option of cantilever steel beams or concrete floor slab for first floor side extention though maybe need additional permit . Bedroom 3 will slightly Bigger than original, Plan A Plan B - Very Narrow Hallway Plan C - With Cantilever

Rinked, I also considered that, but the table and chairs would block access to the back garden. The front extension would significantly block most of the south-facing light in the living area, the back double doors, are north-facing so they don't bring in any light. So while I agree that you need some sort of entrance into the home, The front extension is a mistake in my opinion. In regards to the comment of keeping the passage, yes it's good to have, however, soo many people who live in terrace houses don't have that option and I don't see that as a significant issue.

That could work, thank you!