Thanks ybrough ! I have gone for white ! Will def post the results !!! I've another little dilemma ! Since I'm a perfectionist this has been bothering me !!! We got the shower head fitted in a slightly wrong postion so after movjng it we were left with a hole in the corner of the tile which we got Filled with grouting . It's not obvious I think only I would notice it. It's one of the tiles that's in the shower . Should I leave it alone or chane the tile ??? Problem with changing the tile is that the tiles around it might get chipped in the process ? That's what I've been told . Any thoughts or suggestions would be very appreciated ! Thanks

Hi there, yes, a bit of an issue. Was a height specified on a design somewhere, or has the fitter arbitrarily decided on the height? We would normally leave this as an "on site" decision for the fitter to consult the client and agree a height prior to creating/modifying boxing & structure to suit. That should have happened quite early in the build in the case of recessed cabinets. As Sarah correctly indicates, there is no "standard" height and normally there is quite a bit of flexibility, unless you have runs of furniture which include tall units which may set an "upper edge" limit. You don't have this, so now you have a dilemma. While there is no absolute way to determine a "correct" height, as a rough rule of thumb we would get the tallest & shortest adult using the bathroom and measure "floor to eye" height of both, then pick the midpoint between these two heights as the rough centreline for the mirror, then tweak to taste. My gut says yours is slightly higher than optimal, especially given room height. As to what to do - reworking it now is a not insignificant undertaking, as you would need to remove a couple of rows of tiles (to one tile each side of the opening), recut the board, possibly add in some additional noggins, possibly tweak the electrics (if it has been left with insufficient float), then recut and retile the "awkward" bit. Any fitter is going to strenuously resist doing that at this late stage! If he is accurate to drawing, then it would be reasonable for them to expect you to pay for the privilege of such a change. If the design shows the mirror lower, you have a case to tell them to put it right. But expect resistance! If there is no design and you have not been clear that you wish to be involved in setting the height, then you're into a grey "he says, she says" situation, and have to decide how far you want to try and push it. Best of luck!

All would go fine with your combination. I'd advise caution with the darker finishes if you are in a hard water area.

Thank you both @Sonia and @minnie101 for the feedback, I really appreciate it. I have guests over once a month for around 3 nights. I have hooks behind the door for hanging and also bedside tables with draws. I think I also prefer the dressing table option, I guess stool could be a good option instead of a chair. If I have a dressing table with a mirror can I still hang a full length mirror near it on the same wall or would it look odd?