Backsplash help
5 years ago
Featured Answer
Sort by:Oldest
Comments (60)
- 5 years ago
Related Discussions
Help!!! More tiling issues!!!!! Kitchen backsplash this time...
Comments (32)Tiles are one way to introduce some pops of colour in your kitchen. If you are worried about the grout discolouring, use epoxy grout which is more resilient to liquid staining. Also, if you use a coloured grout, discolouration will be less noticeable. If you choose textured tiles with rectilinear edges, grout lines are almost invisible. Using tiles can look more traditional compared to glass or stainless steel. The problem with stainless steel is keeping it looking good. Drip marks and grease are instantly noticeable. Glass is less obvious when splashed. They are both more industrial and modern looking. What about using the same material that makes up your worktop as the splashback? Most manufacturers of manmade worktops also do an 11mm thick splashback and upstand....See MoreNeed help with backsplash.
Comments (20)Hello...great units...I've just ordered similar in cream (again!). In my last house we used bespoke acrylic sheets as splash back (and behind gas range) and I never had any problems with heat. However, for your own peace of mind you might want to get bespoke strengthened glass cut to size. I painted the inside of the acrylic sheet coral (to match the facing wall and it worked very well. This time I think I will use paper (gift wrap or similar...wallpaper might be too thick) with a small repeat pattern, perhaps a retro design, and paste this to the inside of the acrylic/glass. Affix with mirror screws and seal with clear sealant to prevent steam/condensation, etc... Acrylic is cheap to replace if your design preference changes after a few years....See MoreBacksplash advice needed!!!
Comments (3)Do you need a backsplash? What do you want from it? Colour, pattern, or just to protect the walls from splashes (the only reason I think makes sense!) I have no backsplash, my sink is against a wall but it's vinyl Matt and it wipes easily. My hob is on island so no backslash needed. If it's just for behind your hob you can use glass, so not obvious. I would suggest you wait til your kitchen units/worktop/floor is all fitted before deciding, it makes it easier!...See Moreglass backsplash help
Comments (6)Shutterstock [website] supply high quality images, either photo's videos, AI images etc and they're sold under licence on behalf of the original artist, so there's a massive library of images to choose from so you should be able to see the image before approval. Then the glass is screen printed on the reverse before going through the toughening process, all the glass i've seen which has been screen printed has looked stunning and i'd assume your glass supplier would have pictures and samples of their work [decent sized not little 100mm squares]. Cost wise though your cheapest option would be as Sonia says to go down the laminate splashback route which is a diy option....See More- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years agolast modified: 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years agolast modified: 5 years ago
- 5 years ago
- 5 years agolast modified: 5 years ago
- 5 years ago
- 5 years ago
- 5 years agolast modified: 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago
- 5 years agolast modified: 5 years ago
- 5 years ago
- 5 years ago
- 5 years ago



















































Brad