Load bearing wall and doorway??
Nicke James
6 months ago
Featured Answer
Sort by:Oldest
Comments (8)
Jonathan
6 months agoRelated Discussions
Do I need an architect if I am removing a load bearing wall?
Comments (3)We took down a load bearing wall. We contacted a local structural engineering practice, they drew up the plan and did all the calculations. They also recommended some local builders on our request. Then you notify the building control at your local council before work begins, they inspect during the job (for a fee) and they have to sign it off. Building control were pretty relaxed about it because we'd employed a structural engineer to do the calculations, some people just rely on their builder to work it out, not something I would do! It cost something like £300 for the plans and calculations and similar amount for building control inspection - suppose it depends where you live though as to costs....See MoreLoad Bearing Wall?
Comments (5)Is this the same brick wall that's a fireplace as previously discussed in your other post? If it is, then it supports the fireplace above, and no you probably can't remove it. You may be able to amend it and make it nicer to look at, however, you need a builder to actually take a look at it, because from a picture is impossible....See MoreIs it a load bearing wall?
Comments (8)Hi. You need a structural survey, but If you could see a masonry chimney from outside, then something must be holding it up. You should check the cupboard walls to the side of the stair on the first floor. It doesn't look like aligning to the ground floor chimney on the plans, but you should check the dimensions. It might be aligning with the chimney breast. You should also check the attic level if you have any access. If it is a structural wall all the way across, I assume you could still achieve an open plan but a steel beam or steel goal post structure might be required, which comes with a certain price....See MoreCan you add a doorway to a chimney breast alcove wall?
Comments (6)You need to establish the purpose of the wall you want to knock an aperture through. It might well be bracing an outside wall supporting the chimney and holding up the floor above. You can put an aperture in it but you need specialist advice about how to do it- that’s what structural engineers do. Most likely your builder has one they use - make sure you get a copy of the structural engineers recommendation to ensure firstly you haven’t got a builder who thinks he knows as much as a structural engineer and hasn’t bothered employing an expert, and you may possibly need the recommendation for building regs....See MoreJen
6 months agoNicke James
6 months agoNicke James
6 months agosiobhanmcgee90
6 months agotim_baker921
6 months agoNicke James
6 months ago
minnie101