skip to main content

Waterproofing tiled rooftop deck

Daniel Boardman Residential Design

9 years ago

I see the tiled rooftop deck and would like to do this in my future home which will also be in this neighborhood.

Can you tell me more about the construction techniques used to ensure the home sill not leak?

The South 5th · More Info

Sort by:Oldest

Comments (4)

PRO
Acero Construction
9 years ago
last modified: 9 years ago
It's a protected membrane roof. The TPO goes on top of the concrete deck. Followed by 4" dow plaza mat insulation finished with west tile ballast pavers. The benefit of this system is that the roof membrane should last significantly longer and it's fully protected.
PRO
Next Century Modern
9 years ago
Is the deck surface sloped for drainage, or is it level?
Related Discussions
Shower over freestanding bath, without a curtain. Is my plan logical?!
Q
Comments (48)
Free standing baths are only suitable for larger rooms where you have the ability to position the bath with free access all the way round, I regularly remove them from smaller bathrooms when doing re-fits, people like the aesthetics of the free standing bath and plough ahead and install them against a wall, the result is a disgusting accumulation of dust, fluff, pubic hair etc, this will happen quite quickly and you will regret having gone down this route. The concept of having the bath with no curtain is interesting though, in a bathroom around 2.1m square, most of the bathroom will be effected by splashing, the room will need a wet room floor former, and will require that the whole room is tanked prior to tiling, have a look at. (http://www.wetroominnovations.com) I usually use their Maxus formers and Purus gully traps. you can indeed get a flexible waste connection, have a look at McAlpine "Flexcon" range, these are available through any reputable merchants, these are quite substantial and would stand up to semi regular movement, if your free standing bath is an acrylic bath it won't be too heavy, so moving it would be quite straight forward, but I would suggest having small felt pads on the feet to protect the tiled surface, also from a drying point of view, Karcher have a very good little gadget for cleaning windows, which vacuums up the water, I often mention it to clients and any who have bought one have been delighted at how easy it is to use, it will leave the floor almost dry once you have used it, one note of caution would be your choice of floor tile, you will need a porcelain tile that has an R rating, this is a slip resistant rating and would be most advised. another note of caution, because the splashing will not be controlled, any vanity or wood based furniture will deteriorate. I hope this is of some help.
...See More
Flat Roof Balcony Fiasco
Q
Comments (12)
Hi - been there done that! Start again! OK I can see there is enough clearance below the door to allow a decent fall to be created if its not enough already. This can be done using pressure treated timber firings which are essentially lengths of timber cut and tapered to dimensions according to a plan such as my example below (I realise your balcony is much smaller but you should get the idea). My firrings plan and cutting list shows 3 drain points with the firrings mitred to created falls toward relevant drain. Your local timber supplier should be happy to cut these and pressure treat resulting tapered timbers which would be fixed at 300 centres max and would have 20mm min marine plywood screwed on to them at 150mm centres. OSB 3 roofing 'chipboard' which can come in tongue and groove form would also work, I just prefer ply. They need to be planned out so that the fall of the timber firrings sends any water toward the drainage channel (if there isn't one then create one) or to the edge of your balcony where the rainwater gutter will collect it. Then use RESITRIX - we used this supplier, but there are plenty out there.... http://www.rubber4roofs.co.uk/shop/epdm-rubber-roofing which is a much stro nger version of EDPM rubber and can withstand foot traffic as it is reinforced with fabric making it almost like a wet suit - its a fantastic quality product believe me!. You paint on a black primer on to the ply, then peel the backing off the RESITRIX and apply. Be warned - as experienced people (but not exactly specialist roofers) we managed to do this very effectively, but found that extreme care is needed before committing as once the RESITRIX makes contact its sticks forever!! this is especially difficult at internal corners. Only peel back the backing plastic off the RESITRIX rubber a little at a time as you need to hold it up off the deck to ensure it doesn't make contact in wrong place. two pairs of hands can help!!If you have planned the falls correctly so that the water is sent to the drain, you will now have that long awaited water tight balcony! Now Google 'tiles for decks and balconies' and you will find no end of options of special porcelain or ceramic tiles with plastic adjustable feet for each corner of tile which allow you to place the feet and tiles level on top of your RESITRIX flat roof with no risk of penetration pif the rubber. Water goes between the tiles as they are not grouted, just placed on the feet. Not sure if the tiles you have will work without cracking - you could test this by standing on one which is supported only at corners. by the way RESITRIX happens to be one of a range of flat roof solution I have used including Kemper liquid rubber system (which is reinforced by a fleece like fabric which is simply rolled out onto a bed of liquid rubber then soaked on top with more rubber) Messy but effective, a similar process to GRP. Have also used one piece EDPM rubber which a very competent DIY'er can fit. A very economical and speedy solution, but not good for foot traffic - although they are starting to introduce reinforced versions. We are actually going to use slate grey plastic/wood composite decking http://www.wpc-decking.co.uk To do this we will PLACE a new set of firrings on top of the completed rubber deck but also will stick strips of RESITRIX to underside of firings for protection. now we will have a deck that can be lifted for maintenance in future if required. These firrings are the opposite of the ones used to create the falls, which brings the deck back to level of course! In reality we will actually adjust to maintain a slight fall so that, and the gaps in the deck takes water away. A long answer - I hope that it helps! Best of luck! Nick Wall Design + Build 07745581167
...See More
How to make an asphalt roof into a terrace?
Q
Comments (6)
Hi Eggnog, There is a liquid applied product called Kemperol which can be painted over existing asphalt roof finishes, and then this will give you a new roof waterproofing warranty, and can also allow paving slabs/stones to be affixed. I believe it needs a binder and a sand 'dusting' on top of the finish before the slabs are laid. One other quick point - presumably this is already a roof terrace? There may be planning implications otherwise ....
...See More
Composite Decking Rooftop Balcony
Q
Comments (2)
That looks great. What composite wood did you use? Price per m2?
...See More
PRO
Acero Construction
9 years ago
It slopes a 1/4" per foot
PRO
DeckExpert.com
8 years ago
https://www.duradek.com/_customelements/uploadedResources/WhitePaperTiledek.pdf

Read this then get an architect.

Sponsored

More Discussions

Help…dilema I need some ideas

20

Does anyone know of a washer dryer that is less than 45cm deep?

9

Paint, wallpaper feature or painting?

7

Help! frustrating kitchen with too many doors!

2

Help reconfiguring the downstairs of my house

6

United Kingdom

Tailor my experience with cookies

Houzz uses cookies and similar technologies to personalise my experience, serve me relevant content, and improve Houzz products and services. By clicking ‘Accept’ I agree to this, as further described in the Houzz Cookie Policy. I can reject non-essential cookies by clicking ‘Manage Preferences’.