selected the wrong floor tiles!!
Minfas Afan
7 years ago
Featured Answer
Sort by:Oldest
Comments (12)
sksj1
7 years agoMinfas Afan
7 years agoRelated Discussions
Tiling went wrong - Help
Comments (8)I agree with Matthew, a professional would realise sooner his mistake and correct it straight away. If he doesn't want to pay, just remind him he has insurance, otherwise what is the point of having it! I could have suggested to use Porcelain tiles which we supply they are 4 mm thick so very thin tiles, they would still conduct heat etc........, but there is no point adding to someone mistake trying to rectify it. Best way is always to do it right as it should has been done in the first place. just one more thing make sure that whoever does the tiling will agree on whatever surface he will tile onto, so the tiler everything first so he want have any complaints later....See MoreHelp!!! Off-white hex floor tiles clash with white wall tiles/plumbing
Comments (39)Jonathandb1972, I was thinking of going with a grout that is the same colour or lighter than the grey tile. The hex will be grouted in a medium grey. This has already been done in the loo (the hex) and looks great. Neither are grouted in the above picture. Do you think there will still be issues with where the grout lines are if they are the same or lighter than the tile? Also, where the hex tile in the shower meets the grey tile will mainly be covered by the shower's profile. However, the shower only goes up to about 2m, so there will still be a visible "meeting" of tiles above that. My builder is a little concerned about how this will look as he will have to cut small pieces of tile to fill up the edge, which may stain once they start grouting. I'm keeping my fingers crossed and hoping for the best......See MoreHelp! Has our polished concrete patio gone wrong?
Comments (12)Hi Felicia, sorry to hear that this has happened to you too. It sounds like you have had a similar floor to us - was yours a poured concrete floor i.e. you had an 8-10mm topping poured on top of a screed? Do you know what make of material was used? So, over a year on from my initial post, we ended up having to pull the floor up and get it re-done by someone who knew what they were doing. This time, we ended up going for a solid slab of concrete which was polished up and looks great (but it cost a hell of a lot more!). The bubbles would have created problems outside in terms of water getting in, freezing, expanding and then cracking the concrete over time. But, when I was looking for a new contractor to re-do the floor (we didn’t pay the other guy anything), one of the contractors who was excellent stated that they could have repaired the floor with all of the bubbles. Essentially, the floor hadn’t been primed properly and this sort of thing can apparently happen if there are big differences between the substrate and air temperatures. They mentioned that there was a way to grind down a layer and fill in the holes so I wouldn’t despair just yet. It is a shame that your contractor is being unhelpful - ours was too. I can only suggest trying to call around some other contractors to see what can be done in the first instance. Alternatively, a lot of resin floors can now give a very similar effect to polished concrete but the cost is not cheap. Please feel free to come back to me if you need to as I know how disappointing this sort of thing is....See MoreDecision for floor tiles
Comments (6)hi agree, wallpaper looks great I'd opt for medium format tiles with the size of bathroom you have and if there is enough light then maybe even go for darker tone....See MoreA B
7 years agoCarolina
7 years agoEvolve Interior Design
7 years agoDaisy England
7 years agoMinfas Afan
7 years agoUser
7 years agolast modified: 7 years agoMinfas Afan
7 years agoCarolina
7 years agoMinfas Afan
7 years ago
Evolve Interior Design