advice on flooring please!
Kerry Ansell
6 years ago
Featured Answer
Sort by:Oldest
Comments (10)
A S
6 years agoUser
6 years agoRelated Discussions
Open Plan Flooring
Comments (1)Might be an idea to add a cork expansion strip !...See MoreAdvice needed on flooring please
Comments (1)You should consider Amtico, Karndean or similar...See MoreHelp! Unusual floor plan - kitchen extension advice please
Comments (3)So, has the approach to your property changed at some point? Because I would expect your entrance hall and front door to be at the front and not at the back? Could you turn it around again? If not, maybe move the front door to what is now the kitchen, making the kitchen part entry hall and part utility (dividing wall). Then you could perhaps create one large kitchen/diner/family space from the current utility, office and family room. The current dining room could be an office? Obviously all depending on whether all that would be possible re: load bearing walls and all that....See MoreGround floor, flooring (bamboo) and underfloor heating advice please
Comments (12)I am about to have electric UFH by ukwarmfloor.com - a norwegian system that has been around for ages over there. ( I do not work for them in any way!) Running costs are MASSIVELY cheaper than our versions. Over there, they instal the mats under roofs, drives and on the decks of icebreakers - they know a thing or two about snow and cold, and so I am giving it a whirl in my guest bedroom and large en suite. This is a response from the man answering all my many questions: "The system as shown would use a total of around 375Wper hour to keep all the areas heated to a constant 26C at floor level. By way of comparison the most efficient cable underfloor system would use 975W per hour to achieve this, whilst a boiler & radiator system would use 750W per hour. Comparisons in terms of BTUs can be a little confusing as most standard tables stating average BTU requirements for domestic situations are based on the heat output of traditional radiators etc. So our system only uses 375W (given as approx 1279BTUs in traditional thermal conversion tables)to do the job that a traditional boiler/radiator system would need 750W to do(given as approx 2559 BTUs). Our system is primarily designed specifically to produce the same air temperature in a room as other systems but to use less power to do so. The two basic reasons for this are: The heating element is self-regulating - only ever drawing the minimum required power at any individual point across the floor to maintain the set temperature. 2. The heating element heats the entire floor area and so effectively turns the whole floor of the the room into a radiant surface, heating the entire volume of air in the room from the bottom up. This is unlike radiators, which only heat a small surface, typically at the sides of a room, or a cable or piped underfloor system which can only heat thin strips of floor, leaving most of the floor surface unheated. Because our system heats the entire area it need only heat to 26C to produce effective air temperatures in the room. Other systems have to heat to much higher temperatures to do this and so require more energy to do so." I have spent an inordinate amount of time reading everything on their system, and I am going to use it. There is also a video of a customer installing it on youtube and the link is on their site somewhere....See MoreUser
6 years agoEmily
6 years agoEmily
6 years agoWalls to the floor
6 years agoChris
6 years agoWoodpecker Flooring
6 years agosarah67534
6 years ago
Chris